Maxwell Anchor Winch Reversing Solenoid 12 Volt 2 / 4 Pole – P100715 (SP5102)

Maxwell Anchor Winch Reversing Solenoid 12 Volt 2 or 4 Pole (SP5102)

Suits 12V Maxwell HRC, RC6 and RC8-6.

Dual Direction Solenoids:-

Dual Direction Solenoids are used in conjunction with remote Up/ Down panel, AutoAnchor™ Rode Counters, roving hand held remote controls and/or foot switches to switch the motor in the required direction.

• Heavy-duty solenoids, suitably rated for our winch motors
• Available in 12 or 24 VDC control coil voltage
• Contacts suitable for voltages up to 48 VDC and configured for
  • Single direction motors
    • Single pole normaly open <2kw
  • 2 and 4 terminal motors (PM/FW)
    • Polarity reversing <1.2kw
    • Polarity reversing <2.5kw 3 terminal motors (SW)
  • Pole switching <2.5kw
• Ignition protected solenoids
• IP 66 rating
• Installation in a dry area is always recommended

Downloads:

• <Maxwell Anchoring Systems Catalogue 2021-22
• <Maxwell Solenoid Selection Chart (PDF)
• <SP5102 (12V) and SP5103 (24V) – 2/4 Pole Reversing Solenoid Wiring Diagram to suit 2 Terminal Motor
• <SP5102 (12V) and SP5103 (24V) – 2/4 Pole Reversing Solenoid Wiring Diagram to suit 4 Terminal Motor
• <SP5104 and SP5105 – 3 Pole Reversing Solenoid Wiring Diagram to suit 3 Terminal Motor

Options:

NB: Single Direction Solenoids:- should only be used where single direction motor rotation is necessary. e.g. capstan winches.

• SINGLE DIRECTION SP1393 12 VDC (PM/SW <15KW 40% DUTY)
• SINGLE DIRECTION SP1394 24 VDC (PM/SW <3KW 40% DUTY)
• DUAL DIRECTION SP5107 24 VDC (FW <3KW 40% DUTY)
• DUAL DIRECTION SP5102 12 VDC (PM <1KW 40% DUTY)
• DUAL DIRECTION SP5103 24 VDC (PM <2KW 40% DUTY)
• DUAL DIRECTION SP5104 12 VDC (SW <1.5KW 40% DUTY)
• DUAL DIRECTION SP5105 24 VDC (SW <3KW 40% DUTY)
• DUAL DIRECTION SP5106 24 VDC (SW <3KW 100% DUTY)<